FINAL SAND TECHNICAL DATA SHEET

 

USES:

(1.)  QUICK PREP OF PANELS FOR BLENDING COLOR AND CLEARCOATING

(2.)  EASY PREP FOR SAIL PANEL BLENDING (BETWEEN QUARTER PANEL AND ROOF)

(3.) USE ANYWHERE A D.A. CANNOT REACH

(4.)  QUICK AND EASY PREP FOR BARE UNPRIMED URETHANE BUMPERS AND OTHER PLASTIC PARTS

(5.)  USE AS A FINAL SAND TO CLEAN ENTIRE JOB AND ENSURE THERE ARE NO AREAS THAT WERE MISSED IN EARLIER PREP STAGES

 

INSTRUCTIONS:

USING FINAL SAND IS EASY AND EFFICIENT;

(1.) WET PANEL

(2.) APPLY SMALL AMOUNT TO GRAY OR WHITE SCRATCH PAD

(3.) SAND AREA TO BE PAINTED

(A.) BE SURE TO USE A SYSTEMATIC APPROACH TO ENSURE THERE ARE NO MISSED SECTIONS.

(4.) RINSE WITH WATER

(5.) APPLY BASECOAT/CLEARCOAT DIRECTLY. NO NEED FOR

MID-COAT ADHESION PROMOTER OR SEALER. (NEW PLASTIC PARTS

SHOULD BE WIPED DOWN WITH ISOPROPYL ALCOHOL AND

TREATED WITH A QUALITY PLASTIC ADHESION PROMOTER

IMMEDIATELY PRIOR TO PAINTING).

 

HELPFUL HINTS:

(1.) BLENDING INTO SAIL PANELS & SIMILAR AREAS USE A GRAY

OR WHITE SCRATCH PAD WITH LIGHT PRESSURE. SAND PAST

WHERE THE END OF THE BLEND WILL BE. WHEN PAINT IS CURED,

SIMPLY GIVE A QUICK BUFF TO THE BLEND AREA. IF DONE

PROPERLY, THIS TECHNIQUE IS QUICK, EASY AND RESULTS IN

A SUPERIOR BLEND WHICH WILL NOT PEEL BACK. NOTE: SOFT,

NON-FULLY CURED PAINT WILL WANT TO PEEL BACK. ALWAYS

BE SURE PAINT IS ALLOWED THE PROPER TIME TO CURE!

 

(2.) WHEN TO USE FINAL SAND; AFTER ALL DRY SANDING IS

COMPLETED, USE FINAL SAND TO PREP THE PANELS TO BE

BLENDED INTO AND TO QUICKLY GO OVER THE ENTIRE JOB.

NOT ONLY DOES THIS ELIMINATE MUCH OF THE TEDIOUS AND

TIME CONSUMING HAND SANDING, BUT IT ALSO CLEANS THE

SANDING DUST AND OTHER CONTAMINANTS FROM THE AREA

TO BE REFINISHED. THIS RESULTS IN LESS PREP TIME AND

CLEANER JOBS, WHICH IN TURN REDUCES TIME SPENT BUFFING

DIRT OUT OF YOUR PAINT JOB. YOU GET SUPERIOR RESULTS IN

LESS TIME, WHICH MEANS MORE PROFIT.